DIY Wine Cork Place Card Holders: A Step-by-Step Guide

[thanhcongcraft]

Creating wine cork place card holders is a fun and easy DIY project.

Here’s a step-by-step guide to help you make them:

Materials Needed​

• Wine corks;
• Sharp knife or craft knife;
• Cutting board;
• Cardstock or place cards;
• Pen or marker.

Instructions​

1. Gather Wine Corks:
   • Collect enough wine corks for each place card you need. You can use new corks or recycle old ones.
2. Prepare the Work Area:
   • Set up a clean, flat surface to work on. Use a cutting board to protect your surface.
3. Cutting the Corks:
   • Option 1: Slice a slit for the card:
     • Hold the wine cork firmly on the cutting board.
     • Use a sharp knife or craft knife to make a horizontal slit along the length of the cork. The slit should be deep enough to hold the card securely but not so deep that it cuts the cork in half. Aim for about a quarter to a half-inch deep.
   • Option 2: Cut a flat base for stability:
     • If you prefer the corks to lie flat, slice off a small section along the length of the cork to create a flat base. This will prevent the cork from rolling and ensure it stands upright.
4. Insert Place Cards:
   • Write the names on the place cards or cardstock.
   • Carefully insert each card into the slit you made in the cork.
5. Optional Decorations:
   • If desired, you can decorate the corks. Consider painting them, adding ribbon, or gluing on small embellishments to match your event's theme.

Tips​

• Use a sharp knife to make clean cuts and avoid crumbling the cork.
• Be cautious while cutting to prevent injury.
• If the corks are too hard to cut, try steaming them for a few minutes to soften them slightly.

These wine cork place card holders add a charming touch to any table setting and are perfect for weddings, parties, or holiday dinners.

Source: https://thanhcongcraft.com/how-to-make-wine-cork-place-card-holders/